I had a problem adding an Intel 2200BG card to my NX7000 After installing the card, and download and install the new Bios version 53 the next message appaers after rebooting the computer "104-unsupported wireless network device detected" this card is approved by HP but the Bios not recognized this wireless device, could I obtain a net patch or fixed solution to update my computer with the latest BIos? or do I need to return to 3.4 version in order to continue using this wireless card or do I need to buy a different wireless card for my computer?
Note: If you are the author of this question and wish to assign points to any of the answers, please login first.For more information on assigning points ,click
here
1. I reverted to an older bios on the zt3017ea v.F34, any newer version blocks this card instead of removing and reinserting it which did not work for me. 2. I used Koppix v 3.9 3. I skiped the ipw2200.tar.gz part
I have a solution thanks to whiteheat and druid cz from x1000 forums that allows you to use any Intel Pro Wireless 2200BG card inside your HP laptop.
Before, I received the error 104: unsupported wireless card, now my NC8000 laptop will boot perfectly. Now you can buy your card for < ã25.00 instead of HP's ã60 + vat + p&p.
First off if you don't have linux installed you will need to go to www.knoppix.org and download KNOPPIX_V3.8.2-2005-05-05-EN.iso, then burn the cd
You need to have the card install during the boot sequence so, have your laptop open and bootup, when you see the boot:_ line insert the card then press enter. Knoppix will autodetect the card & the bios wont complain.
Once knoppix has booted:
Click on the penguin on the taskbar and select "Root Shell", then the following command (from now on any line that begins with a # is a command to be typed at the Root prompt: #iwconfig You will get a list of ethernet adapters, eth0, eth1 etc. The wireless one should be quite obvious from the text displayed after it with all the wireless parameters! #ethtool -e ethX Obviously replace the 'X' with the index of your wireless card you found above. You will get a hex dump of the 256 bytes of EEPROM data. Note: There is nothing dangerous in the above steps at all.
If you want to writing to your EEPROM (You can seriously screw your card up so be careful ):
Printable version
