i want to install SLES 11 on my Proliant DL320 G6 (Smart Array Controlle rB110i)...
I activated the onboard Raid Controller and builded 2 arrays (4 hdd)...
Were can i download the driver for the controller? SLES10 shows all 4 hdd in the setup - i don´t see the array?!?!
Any ideas
Note: If you are the author of this question and wish to assign points to any of the answers, please login first.For more information on assigning points ,click
here
This was found from the standard location for support downloadables for HP Proliant products:
http://www.hp.com/go/support -> select "Download drivers and software (and firmware" -> type in your model (i.e "DL320 G6") and press Enter -> select your OS -> in this case, look for category "Software - Driver Diskettes". After the basic OS installation is done, you might want to install other stuff too for your convenience (at least check out "Driver - System Management" and "Software - System Management")
The hpahcisr driver is required to access the B110i controller as a RAID device.
This driver is not yet available for SLES11, but it should be available soon on hp.com - please check back around mid November.
You can of course use these devices with the open source drivers provided by SLES11, and the distribution-provided software RAID support. But, be warned that there is no migration path to the hpahcisr driver, other than a backup/restore of all of your data.
Also note that hpahcisr is currently available for SLES10.
Printable version
